For the complete documentation index, see llms.txt. This page is also available as Markdown.
EVPAY Configuration
After the Verifone M400 terminal is installed, it must be configured for use with the VIPER. Before beginning, obtain the following network settings from the network host:
IP Address
SSL
Mask
Gateway
DNS
Accessing Configuration
1
Access the Welcome Screen
If the screensaver is scrolling, tap the screen to access the Welcome Screen.
2
Open Configuration
At the Welcome Screen, press #,6,#,6 quickly. The Enter Configuration Password screen appears.
3
Enter the password
Key in the password (69900) by pressing the number keys on the keypad.
4
Confirm the password
Tap the green check box or press the green circle button on the keypad. The main Configuration screen appears.
Network Settings
Use the Configuration screen to access the Network Settings.
1
Access Configuration
Access the Configuration screen and enter the password. See “Accessing Configuration” for information about locating the screen.
2
Open Network Settings
Tap Network Settings. The Network Settings screen appears.
3
Enter network values
Tap the screen to enter the values using the keypad.
Settings
Action
IP Address
Key in the IP Address.
SSL
Tap to enable or disable SSL.
Netmask
Key in the Subnet Mask.
Gateway
Key in the Gateway.
DNS1/DNS2
Key in the DNS addresses should be obtained from the Site Network Administrator. Alternatively, the following public DNS addresses can be used:– 8.8.4.4– 8.8.8.8
4
Save or discard changes
Tap Apply or press the green circle button on the keypad to save the settings.
Tap Cancel to discard the changes and exit Network Settings to the Configuration menu.
Downloads
Use the Configuration screen to access the Downloads.
1
Access Configuration
Access the Configuration screen and enter the password. See “Accessing Configuration” for information about locating the screen.
2
Open Downloads
Tap Downloads. The Downloads screen appears.
3
Download a file
Tap the file to download and follow the prompting.
4
Exit Downloads
Tap BACK to exit Downloads to the Configuration menu.
EMV Information
Use the Configuration screen to access the EMV Information.
1
Access Configuration
Access the Configuration screen and enter the password. See “Accessing Configuration” for information about locating the screen.
2
Open EMV Information
Tap EMV Information. The EMV Information screen appears.
3
Exit EMV Information
Tap BACK to exit EMV Information to the Configuration menu.
RFID Support
Use the Configuration screen to access the RFID Support.
1
Access Configuration
Access the Configuration screen and enter the password. See “Accessing Configuration” for information about locating the screen.
2
Open RFID Support
Tap RFID Support. The RFID Support screen appears.
3
Disable RFID
Tap the check box to disable RFID. RFID is enabled by default.
4
Save or discard changes
Tap Apply to save the settings.
Tap Cancel to discard the changes and exit RFID Support to the Configuration menu.
VHQ Configuration
Use the Configuration screen to access VHQ Con.
1
Access Configuration
Access the Configuration screen and enter the password. See “Accessing Configuration” for information about locating the screen.
2
Open VHQ Configuration
Tap VHQ Configuration. The VHQ Configuration screen appears.
3
Configure VHQ values
VHQ Agent Version — Displays the current Agent version.
Store ID — Select to manually configure the Store ID up to 40-digits. The value will be displayed below at VHQ Store ID. If not selected, the EPS sends the value or the value displays zero.
Lane ID — Select to manually configure the Lane ID up to 3-digits from 1-128. The value will be displayed below at VHQ Lane ID. If not selected, the EPS sends the value or the value displays zero.
Service ID — Select to manually configure the VHQ Service ID. The value will be displayed below at VHQ Service ID. If not selected, the value displays zero.
