Minimum 8GB RAM Requirement
What site operators need to know before upgrading to Base 057.01.00 or higher
Released
Base 057.01.00
Applies to
All Commander sites running Auto Upgrade
Action required
Verify your Commander has at least 8GB of RAM before upgrading
Overview
Starting with Base 057.01.00, the Commander requires a minimum of 8GB of RAM to operate. This is a new minimum hardware requirement introduced to support the performance and stability improvements in Release 57.
If Auto Upgrade (AU) is initiated on a Commander that does not have enough memory, the upgrade will be automatically blocked before any changes are made to the system. Your site data is fully preserved in all cases.
Supported Memory Configurations
The table below shows which memory configurations are supported for upgrading to Base 057.01.00 or higher.
One 8GB module
8 GB
✓ Supported
Two 4GB modules
8 GB
✓ Supported
One 16GB module
16 GB
✓ Supported
Two 8GB modules
16 GB
✓ Supported
One 4GB module only
4 GB
✗ Not Supported
Two 16GB modules
32 GB
Not Supported
Error Messages
When Auto Upgrade is blocked, one of the following messages will appear on screen. The message depends on the reason for the block.
Error E9080 — Insufficient Memory
“The upgrade is aborted because the system does not meet the minimum memory requirement. Please contact a VASC Technician to ensure the minimum of 8GB RAM memory is installed.”
Error E9078 — Incompatible Device Detected
“The upgrade is aborted due to detection of a device that is EOL. Please contact a VASC Technician to remove any incompatible devices before proceeding with a software upgrade.”
Both types of failures are logged automatically and are available to Verifone support for diagnostics.
What to Do If Your Upgrade Is Blocked
Note the error code displayed on screen — E9080 (memory) or E9078 (incompatible device).
Contact a VASC Technician : • For E9080: The technician will upgrade the Commander RAM to at least 8GB. • For E9078: The technician will remove the incompatible End-of-Life device(s) from the network
Once the hardware issue is resolved, the VASC Technician will retry the Auto Upgrade.
Auto Upgrade will complete normally once the requirements are met.
Your site data is safe. The upgrade block happens before any changes are applied to the Commander, so no data is lost or changed regardless of the outcome.
Frequently Asked Questions
Will my site stop working if the Commander has less than 8GB today?
No. This requirement only applies when upgrading to Base 057.01.00 or higher. A Commander already running an earlier software version continues to work normally. The RAM check only runs during the Auto Upgrade process.
Can I retry Auto Upgrade after the technician fixes the hardware?
Yes. Once the VASC Technician has confirmed the Commander meets the 8GB minimum — either by upgrading the RAM or removing incompatible devices — you can initiate Auto Upgrade again and it will proceed normally.
Does this apply to all Commander sites, or only certain networks?
This requirement applies to all Commander installations regardless of the payment network (Buypass, Chase, Chevron, NTS, WorldPay, etc.).
What if my Commander shows both error E9078 and E9080?
The upgrade will block on whichever condition is detected first. The VASC Technician should resolve both issues — remove any incompatible devices and ensure 8GB of RAM is installed — before retrying the upgrade. This prevents the upgrade from failing again for a different reason on the second attempt.
How do I know how much RAM my Commander currently has?
Your VASC Technician can check the installed memory on the Commander. You can also contact Verifone support for assistance identifying your hardware configuration before scheduling an upgrade.