Some content on this site may not be available right now. We are aware and actively monitoring the situation.
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Gilbarco FlexPay II CRIND

Verification of TLS Certification

The TLS Certification enhances a secure communication between the Gilbarco CRIND and Verifone Commander. Gilbarco FlexPay II CRIND does not always come loaded with a TLS Certification. Using the Advanced FlexPay Maintenance Tool, the TLS Certification can be verified and loaded if necessary.

  1. Open the FlexPay Tool and connect to the FlexPay Control Board.

  2. Select the TLS tab.

  3. Select Show Hierarchy List button.

  4. If the TLS Certification is installed, the TLS files will be listed.

5. If the Certification is not installed, then the error window below displays. Contact Gilbarco for steps and instructions on how to install the TLS Certification in the Gilbarco CRIND.

Verification of Single-Auth TLS Mode

The TLS Certification enhances the secure communication between the Gilbarco CRIND and Verifone Commander. Gilbarco FlexPay II CRIND does not always come loaded with TLS Certification. Using the Advanced FlexPay Maintenance Tool, the TLS Certification can be verified and loaded if necessary.

  1. Reboot the CRIND and enter Service Menu with dispenser password.

  2. From the Service Menu, select option <3> Security Setup Menu.

  3. Enter Matching Password. This requires a call to Gilbarco TAC.

  4. After entering the Security Setup Menu, select <3> Protocol Menu.

  5. Verify that option <1> CRIND TLS Authentication is set: ON SINGLE AUTH.

POS COMM set to IP

The outdoor EMV communication from the Verifone Commander to the CRIND is in the TCP/IP protocol. Previously Verifone Commander communicated in a SERIAL protocol. For the CRINDS to accept the TCP/IP protocol, the settings on the CRINDs needs to be changed.

Using the Gilbarco Diagnostic, enter into Diagnostic Startup Menu. Press '1' and Enter for Main Menu.

Press '1' and Enter for CRIND Config.

Press '3' and Enter for POS Comm Config.

  1. Press '1' and Enter to Set POS COMM Mode to IP.

If the POS Comm Mode is already set to IP, then Cancel out of the POS Comm Config settings.

After the POS Comm Mode is set to IP, press the Cancel key until back at the Diagnostic Startup Menu.

Press '2' and Enter to Exit the Diagnostics. This will warm reboot the CRINDS.