FEP Card
The FEP Card tab allows card information parameters to be set for each FSA card used on site.
Configure a FSA Card
1. Select the [FEP Card] tab from the Full Service Attendant Configuration window.

2. Select [Add] before entering card information.
• Delete: Allows existing card information to be deleted.
3. Configure the Card Information parameters.
Card Information
Card Table Index
Sets the record number of the FSA card (alphanumeric, ten digits).
This number cannot be changed after a card has been saved.
Card Abbreviation
Sets the abbreviation for the given card (alphanumeric, two digits).
Card Name
Sets the name of the FSA card (alphanumeric, 12 digits).
Lower ISO
Sets the low value of the card range (four digits 0001 - 0015). The entered card number must be greater than or equal to this number to match the table entry. The Card ISO values are supplied by the card provider.
When using a Verifone Full Service Attendant Card (PN P040-10-900), do NOT use "==" preceding the lower ISO range for the card.
Upper ISO
Sets the high value of the card range (four digits 0001 - 0015). The entered card number must be less than or equal to this number to match the table entry. The Card ISO values are supplied by the card provider.
When using a Verifone Full Service Attendant Card (PN P040-10-900), do NOT use "==" preceding the upper ISO range for the card.
Pan Length
Sets the number of digits the card is assigned (14 digits). Values are supplied by the card provider.
When using Verifone Full Service Attendant Cards (PN P040-10-900), set the Pan Length to "14".
Card Enabled
Select to enable the FSA card at the DCR.
Select [Save] to accept, or [Cancel] to exit without saving changes.