Some content on this site may not be available right now. We are aware and actively monitoring the situation.
For the complete documentation index, see llms.txt. This page is also available as Markdown.

Configuring with Verifone Commander Configuration Client

1

AVI IP address

Obtain the AVI IP address from the Orpak AVI technician.

2

Managed Modules

From the Verifone Configuration Client, go to: Tools > Managed Modules.

The Managed Modules window displays. The following tabs are available for selection:

  • Current Configuration

  • Pending Configuration

  • System Resources

3

Current Configuration

Select the [Current Configuration] tab.

4

Fuel RFID Configuration

Select [Fuel RFID Configuration].

5

Parameters

Configure the Fuel RFID Configuration parameters.

Value
Description

RFID

AVI enable

Select to enable AVI.

AVI IP Address

Sets the AVI IP address that must match what is programmed on the AVI controller.

OTI enable

Select to enable OTI.

OTI IP Address

IP address for OTI.

OTI is a company which produces an RFID system similar to that of ORPAK. It has been included for future interface support but is not currently used.

6

Save or Cancel

Select [Save] to accept, or [Cancel] to exit without saving changes.

The MWGT will be installed on the store LAN. The store router must have a path configured between Verifone Commander and the MWGT.

The configured address must be within the RFC1918 defined range for private IP addresses. Addresses attempting to access the POS Zone that are not within the RFC1918 scope will be denied.